ÎOW YOU'RE READY TO INSTALL THE 64Ë 
 CHIPS IN THE SOCKETS, CAREFULLY 
 INSPECTING THE PINS FOR PROPER 
 ALIGNMENT. ÍOST OF THE TIME CHIPS 
 WILL BE MADE SO THAT YOU WILL HAVE TO 
 BEND THE PINS INWARD, TOWARD THE 
 CENTER, TO FIT PROPERLY IN THE 
 SOCKET. ÂUT TOO MUCH BENDING WILL 
 BREAK OFF A PIN. 

 ÏNCE YOU'VE INSTALLED THE CHIPS 
 YOU'RE READY TO START THE REASSEMBLY 
 PROCESS, JUST REVERSE THE DISASSEMBLY 
 STEPS AND MAKE SURE TO SOLDER THE 
 GROUND CASE HALVES AGAIN. ÒECONNECT 
 YOUR CABLES AND POWER UP THE 
 COMPUTER. 

 ÉF ALL WENT WELL, YOU SHOULD SEE 
 ÎÏÔÈÉÎÇ ÕÎÕÓÕÁÌ. ÔHE SAME OLD COLD 
 START UP MESSAGE AND NOTHING 
 DIFFERENT. ÓOME OF YOU MIGHT NOTICE A 
 DIFFERENT PATTERN ON THE SCREEN WHEN 
 THE INITIALIZATION PROCESS IS GOING 
 ON BUT AFTER THAT YOU SHOULD SEE THE 
 SAME ÏÌÄ ÓÃÒÅÅÎ. ÔHE COLD START 
 ROUTINES FOR THE Ã-128 INITIALIZE THE 
 ÖÄÃ REGISTERS, AND THE ÖÄÃ CHIP IS 
 TOLD THAT IT STILL HAS THE 16Ë CHIPS 
 IN IT. ÉN ORDER TO TELL THE ÖÄÃ 
 YOU'VE UPGRADED THE ÒÁÍ, YOU WILL 
 HAVE TO SET BIT 4 OF REGISTER 28. 
 ×HEN THIS IS DONE, FOR SOME REASON, 
 THE CHARACTER INFORMATION GETS 
 SCRAMBLED, BUT A CALL TO THE ÃÏÐÙ ÒÏÍ 
 ROUTINE AT $ÃÅ0Ã CLEARS THE PROBLEM. 

 ÉF YOUR SCREEN DOES NOT APPEAR THE 
 WAY IS SHOULD, LOOK FOR A COLD SOLDER 
 JOINT OR A PIN THAT IS NOT INSTALLED 
 INTO THE SOCKET CORRECTLY. É FOUND 
 THAT WHEN É TRIED TO REMOVE THE OLD 
 CHIPS IN ONE PIECE, É HAD DAMAGED A 
 PORTION OF THE COPPER FOIL ON THE 
 CIRCUIT BOARD AND HAD TO TRACE THE 
 CIRCUITS OUT AND INSTALL A JUMPER 
 WIRE FROM THE 8563 SOCKET TO ONE OF 
 THE ÒÁÍ SOCKETS. 

          <ÐÒÅÓÓ Æ5 ÆÏÒ ÍÅÎÕ>